Introduction
Elabscience® PI Reagent (50μg/mL) is
developed to identify apoptotic and necrotic cells.
Propidium Iodide (PI) is a common DNA dye that is
not permeable to cell membrane. Once binding to DNA, the flurescence of PI
increases by nearly 20 fold. Due to the loss of integrity of membrane, PI can
enter late apoptotic or necrotic cells to stain DNA. Cells at different
apoptotic stages can be distinguished by using Propidium Iodide (PI) and Annexin
V.
Components
|
Cat.
|
Products
|
50 Tests
|
100 Tests
|
200 Tests
|
500 Tests
|
Storage
|
|
E-CK-A161
|
PI Reagent (50μg/mL)
|
250 μL
|
500 μL
|
1 mL
|
1.25 mLx2
|
2~8°C
|
|
Manual
|
One Copy
|
Jurkat cells were treated with 5 μM Camptothecin and detected with this reagent
and Annexin V-FITC.
Jurkat
cells were cultured with (Left) or without (Right) 5 μM Camptothecin for 4 h. Annexin V-FITC single-positive cells were early apoptotic cells,
Annexin V-FITC and PI double-positive cells were necrotic or late apoptotic
cells, and PI single-positive cells were naked nuclei.
|
Staining Procedure
1. Induce apoptosis of suspension cells with
reagents of interest. Collect cell cultures, centrifuge at 300 g for 5 min and discard the supernatant. Add PBS to wsh the cells and resuspend
the cells gently followed by the cell counting.
Note: This product is only validated in
suspension cells. Good cell viability is the key to the experiment. When the
adherent cells are used for apoptotic detection, treatments like digestion may
increase the ratio of necrotic or apoptotic cells and cause uncontrollable
effects on the experimental results. Please be aware！
2. Split the cell suspension into tubes, 1-5 × 105 cells for each, centrifuge at 300 g for 5
min and discard the supernatant. Add PBS to wash the cells and discard the supernatant. Add 500 μL of 1 × Annexin V Binding Buffer [E-CK-A151] to
resuspend the cells.
3. Add 5 µl of Annexin V-FITC[E-CK-A111] and 5 µl of PI Reagent (50μg/mL) to
each tube.
4. Gently vortex the cells and incubate at
room temperature for 15-20 min in the dark.
5. Analyze the cells immediately with proper machine settings. Otherwise, place the cells on ice in the dark and analyze within 1 h.
Storage
Store at 2~8°C for one year in dark.
Cautions
1. For maximal assay performance, this reagent should be used within 12 months. Avoid
freeze / thaw cycles.
2. Detect apoptosis as soon as possible after staining to avoid the
increase number of apoptosis or necrosis
3. Avoid extended
exposure of the samples to direct light to protect the fluorophores from
quenching.
4. For
your safety and health, please wear the lab coat and disposable gloves before
the experiments.
Message submitted successfully !